Vulcan-Hart GCO2D Specifiche Scaricare il pdf (Pagina 6)

— 6 —

NOTICE: When the oven is mounted on casters, it must be installed with the casters supplied, a connector

(not supplied by Vulcan-Hart) complying with either ANSI Z21.69 (latest edition) or CAN/CGA-6.16

(latest edition), and a quick-disconnect device complying with either ANSI Z21.41 (latest edition) or CAN1-6.9

(latest edition). It must also be installed with restraining means to guard against transmission of strain to the

connector, as specified in the appliance manufacturer’s instructions. Attach the restraining device at the rear of

the oven (Fig. 1).

Fig. 1

Assembling the Legs to the Single Oven

The 4" (101.6mm) legs are packed inside the oven during shipment and must be installed on the bottom of the

oven. Place the oven on its left side, being careful to avoid scratching the finish. The gas pipe connection

protrudes beyond the back; provide for this when oven is tipped back by resting it on suitable spacers (2 x 4's

etc.).

Thread each of the four leg assemblies into the holes provided on the bottom corners of the oven. Carefully raise

the oven to its normal upright position.

Assembling the Chimney to the Single Oven

Remove the oven chimney from inside the oven cavity and use the screws provided to fasten the chimney to the

top rear of the oven (Fig. 2). The flanges on the chimney are to be positioned over the top cover.

LEVELING

Once the oven is in its permanent position, place a carpenter's level on the oven rack. If the oven is installed on

legs, turn adjustable feet in or out to level oven front-to-back and side-to-side. If the oven is installed on casters,

loosen set screws and turn casters in or out to level oven front-to-back and side-to-side. Retighten set screws

after leveling.

ASSEMBLING STACKED OVENS

Determine which oven will be on the bottom and place it on its left side, being careful to avoid scratching the finish.

Install the four 16

⁄4" (42.5cm) legs, using the 24 bolts and lockwashers provided (6 per leg).

CONNECT GAS

LINE STRAIN

RELIEF HERE

PL-52222

CHIMNEY

PL-52240

Fig. 2

1 2 3 4 5 6 7 8 9 10 11 ... 23 24

Nessun commento

Vulcan-Hart GCO2D Specifiche Pagina 6